Wiggly-Amps Forum

Go to the PC where you would like to install the LGB software and follow these instructions:

• Run the lgbsetup.exe file which should be saved in a shared location on your network
  
  If you cannot locate this file, do not worry you can download another by clicking here or type the following url into the address bar of your web browser www.littlegreenbutton.com/downloads/lgbsetup.exe (save to a shared location on your network)
• Follow the installation wizard through and ensure you leave the tick to launch the program file
• A pop-up will appear thanking you for installing, click Ok.
• Now complete the Settings form
• Most importantly complete the Location of this LGB, normally this should be a unique name and as this is the name displayed on panic alerts should be clear to your staff e.g. Dr Smith's Room or Administrator Office
• Click Done
  

This new LGB will obtain its licence key from the master LGB across your network and should go green immediately. If this does not happen automatically please follow these instructions:

• Never enter a licence key unless this is the very first time you have installed the LGB on any PC!
• Go to your master LGB (If you unsure which this is, right click on any LGB, go to About and the location of the master will be displayed at the bottom of the window which opens.)
• Right click on the master LGB
• Go to System tools, go across and click on Push licence.
• Click Ok on the pop-up which appears saying licence key sent to all users
  

If you have any problems or require further assistance please contact Wiggly-Amps for support:

01263 834648
support@wiggly-amps.com